Categories: Auto Repair

Nissan X-Trail T32 2017 New ECM VIN Programming by Launch X431

This instruction show you guide on how to use Launch X431 PAD V program new ECM VIN for Nissan X-Trail T32 2017.For more Nissan cases, please refer to Nissan Trouble Repair.

 

Preparations:

Launch X431 V Pro or Launch X431 PAD V (Amazon Official Shop)

 

Procedures:

Connect Launch X431 device to Nissan X-Trail T32.

Enter Launch X431 device and select “Nissan” enter “Full system diagnosis”

Select “The Vehicle with 16 PIN”–>”System Selection”–>”Engine”–>”ECM (Engine Control Module)”

 

Select “Special Function”–>”VIN Registration”

Confirm ignition switch on and engine stopped.Hold these conditions during this procedure.

Touch start

Press “OK”

Press “Input”

Input VIN,here you need input it twice.

Press “OK”

Command succeeded.Turn ign sw off for 10 sec then ign sw on to confirm no dtc.

After finish,please go back to VIN menu to double check if new VIN registration successfully.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

10 hours ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago