OPCOM VAXU-COM Reset Electronic Throttle Body

Here i want to show a single guide on how to use OPCOM VAXU-COM to reset electronic throttle body.

When this is needed

After replacement,or cleaning of the electronic throttle body, the Adaptation of the electronic

Throttle Body must be performed.

This procedure must also be carried out, when you take off the negative battery terminal, or

replace the engine control unit!

 

Preparations:

Newest OPCOM VAUX-COM All Version Free Download

OPCOM Clone

 

Which engine codes are supports this operation

  • Z10XE
  • Z12XE
  • Z18XE
  • Z18XEL
  • Z20LET

 

Prerequisities

  • The ECT (coolant temperature) is at normal (warm, about 85 °C)temperature.
  • The engine is not running.
  • Throttle pedal is idle position (please, do not operate the gas pedal during )
  • Battery voltage is greater, than 11 V
  • There is no DTC stored in the engine control unit

 

Performing the Throttle Body Adaptation

  • Choose the engine
  • Click on the [Special function] button.
  • Click on the [Reset learned values] button.
  • Click on the [Start] button.
auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

1 day ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago