It is a nice feature of PCMflash to read & write data from Bosch EDC17C45 ECU EEPROM & Flash data without opening ecu shell,save much time and work.More ECU projects,please check here: ECU Chip Tuning
First you need to follow the connection diagram to build connection between Bosch EDC17C45 and interface for PCMflash.
Then run software to select “Bosch:MEDC17….EEPROM”,then click “Identification”
It will ask you “Would you like to use automatic power control(L-Line)?”
Click “Yes” to continue
After then click “Read” button
Wait a minute for EEPROM data reading
Save the EEPROM data on your pc
Select “Bosch:MEDC17…FLASH”
And click “Read”
This procedures will take you about several minutes
When finishing,just save data on your pc.
Done!
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…