Here is the instruction show you guide on how to solve Perkins 1106D electric power generation E360 low engine oil pressure error.
Preparations:
Perkins EST 2024A & 2023A & 2019A Software Free Download
Perkins SPI2 2018A EPC+Service Manual Free Download
Perkins Communication Adapter 3
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects a fault with the engine’s oil pressure. The ECM detects the following faults:
• The engine has been running for more than ten seconds.
• The oil pressure is below the trip point for the event code. Refer to Table 32 for a list of trip points for low oil pressure.
• Diagnostic code 100-3 Engine Oil Pressure open/short to +batt is not active.
• Diagnostic code 100-4 Engine Oil Pressure short to ground is not active.
Note: This event code represents an event. This does not represent an electronic system fault.
System Response:
The event code will be logged.
The warning lamp will be illuminated and the diagnostic lamp will flash the event code.
Possible Performance Effect:
E360-1
None
E360-3
The derate lamp will be illuminated. The ECM will derate the power at 17 percent per second for two seconds.
The shutdown lamp will be illuminated. If the “Enable Shutdown” parameter is enabled, the engine will shut down.
Troubleshooting:
Refer to Troubleshooting, “Low Engine Oil Pressure”.
Results:
• OK – STOP
More trouble repair case for Perkins,pls refer to:Perkins Trouble Repair