Categories: Auto Repair

Porsche Carrera 4S Sport Exhaust Trouble

A Porsche Carrera 4S made 2014 MA engine with 15 thousands miles,the owner discribed that no chagning voice of the sport exhaust.And technicians found the valve of rear muffler keep closed,and no chagning voice of the sport exhaust.This article talk about topic of how to solved Porsche Carrera 4S sport exhaust trouble.

 

Diagnosis of Trouble:

Here comes a structural schematic diagram of Porsche sport exhaust system,show as below:

1.Front muffler   2.Connector  3.central exhaust valve adjusted

4.each cylinder equipped a main muffler  5.Dual-outlet exhaust

Only follow the requirement to press one of below buttons in the sport exhaust system your vehicle equipped,can you start or stop switch mode from exhaust valve to Acoustic performance optimization.

1. “Sport” button

2. “Sport Plus” button

3. “Sport exhaust system” button

It is the same as the Porsche Carrera S,we need to follow the requirement to start exhaust valve by diagram of DME unit.In this case,DME control unit sent the CAN signal to gateway,it receives the signal from controller and AC unit by CAN.The gateway sent the signal to next electronics,then it enable the electronic control pneumatic switching valve.

 

According to the fault syptoms and schematics,we can determine the possible reasons:

1. Solenoid valve of control valve trouble

2. Valve vacuum pipe failure

3. Sport valve trouble

 

Connect the PIWIS to vehicle and found the trouble code”80730E”

Porsche PIWIS 2 V18.15 V17.500 Free Download

It mean:exhaust valve of rear muffler trouble

And after testing found exhaust voice did not chage.Disconnect the vacuum tube,it did not generate vacuum when opening or closing the switch of exhaust,it implied that solenoid valve of control valve trouble.

 

Located the right rear solenoid valve,it was damaged.

Solution:Replace a new solenoid valve.

auto

Recent Posts

How to Install Left-hand Drum Bearing Assembly for CLAAS LEXION 480

Here is the instruction show you guide on how to install the left-hand drum bearing…

10 hours ago

How to Remove and Replace Loader Lift Ram for JCB 3CX 4CX Machine

This instruction show you guide on how to remove and replace loader lift ram for…

3 days ago

How to Solve Caterpillar C9 Engine Vehicle Speed Loss of Signal Error?

This instruction show you guide on how to solve Caterpillar C9 engine 31 84-1 fault…

6 days ago

How to Perform Accumulator Charging/Discharging for JCB 3CX,4CX

This instruction show you guide on how to charge and discharge accumulator for JCB 3CX,…

2 weeks ago

How to Solve PowerCommand PCC2300 Fault Code 143 Low Oil Rifle Pressure

This instruction show you guide on how to to solve PowerCommand PCC2300 trouble code 143…

3 weeks ago

How to Solve HINO J05E Engine P007B Intake Air Temperature Sensor Error

Here is the instruction show you guide on how to solve HINO J05E engine P007B…

3 weeks ago