This post will show you guide how to use G-Scan to learn Power Steering Control Module (PSCM) for 2013Ford/Lincoln MKS. For more function of G-Scan, please refer to G-Scan2 Test Projects.
Procedure:
Before replacing steering rack assembly, you need to connect a scan tool and be in initialisation mode.
Connect G-scan, click “Diagnosis”
Select Ford USA
Select “AUTOMATIC SELECTION” and correct engine size
Click “System Search”
System Search will scan all available system in the vehicle.
After searching finished, scroll down and select “PSCM(Power Steering Control Module)”
Select “Special Function”
Select “PSCM Module Installation”
Turn the IG ON and hit “OK” button
Turn the IG OFF and hit “OK” button.
Replace entire steering rack assembly
After replacement, go back to the G-scan and finish up the function.
Click “OK” button to continue
Turn the IG ON and click “OK” button
Turn the IG OFF and click “OK” button
Turn the IG ON again and click “OK” button
Module Configuration Complete.
Installation is completed successfully.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…