Categories: Auto Repair

Read & Clear DTC for 2005 Nissan UD Quon by G-scan 2

This article show you the guide on how to use G-scan2 read and clear DTCs for 2005 Nissan UD Quon model. And for more G-Scan 2 test report,please check here:G-Scan 2 Test Projects.

 

Procedures:

Connect G-scan2 diagnostic tool to vehicle DLC port,then enter menu:

Select Diagnosis in the main page

Select  “UD”

Select “QUON”

Select System Search

Hit “Start”

After hit start, you can access to desired system. Select “DTC Analysis”

It shows three DTCs:Boost Pressure Excessive,Boot Pressure Sensor Reference Voltage Out of Rand (Over),Vehicle Speed Sensor No Pulse Signal.If you look at riht state column,it says history.

This means ECU detected a problem and saved the DTC.If the state column is empty,that mens the problem is present.Let is try to earse the codes,hit “Erase”

It will prompt you with below massage:

Are you sure want to erase all DTCs?

Warning:

When there is freeze frame data,freeze frame data is also erased at the same time.

Then,hit it “OK”

Trouble code erasure succeeded.

Done!

auto

Recent Posts

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

2 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

5 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

3 weeks ago