Categories: Auto Repair

Remove car dent by boiling water and plunger

Inevitably,get a dent in your car even if as careful as possible.So,is there any way to repair or remove car dent.Now I share a esay way to remove car dent in 2 step.


Here comes the easy way to remove car dent.

1.Boiling a pot of water,then throwing it on the dents position.In the process of pouring,you need to throw boiling water on dents equably,and lengthen time to make iron of you car body soft.


2. After throwing boiling water on the dents,iron of dents is so soft that you can use plunger to suck the dents.Then forced out to pull,after several adjustments,the dent will slowly repair.During the process of pulling,you need to pay attention to use proper force in order avoid to damage your lovely car.

 

At the end of article you can watch the video guide to get more information about  remove car dents.

auto

Recent Posts

How to Install the Reverser Drive for CLAAS LEXION 480?

This instruction show you guide on how to install the reverser drive for CLAAS Lexion…

17 hours ago

Scania Truck RTI 257 Road Transport Informatics Theft Protection Error

Here is the instruction show you guide on how solve Scania truck RTI 257 road…

18 hours ago

How to Inspect and Clean Cylinder Block for John Deere PowerTech 9.0 OEM Engine

This instruction show you guide on how to inspect and clean cylinder block for John…

4 days ago

How to Remove and Replace Cab Heater Controls for JCB 3CX Loader

Here is the instruction show you guide on how to remove and replace cab heater…

3 weeks ago

How to Remove Differential Gear for FENDT 900 Vario COMIII

Here is the instruction show you guide on how to remove differential gear for Fendt…

4 weeks ago

International MaxxForce 7 SPN 27 FMI 4 EGRP Signal Out of Range Low

This instruction show you guide on how to solve International MaxxsForce 7 SPN 27 FMI…

4 weeks ago