Categories: Auto Key Program

Renault Megane IV 2015+ Key Programming by Zed-Full

This article will show you guide on how to use Zed-Full immobilizer solution to program keys for Renault Megane IV 2015+.

 

Procedures:

Locate OBD port,and plug Zed-Full to OBD port

Enter menu to select “OBD Application”

Select “Renault”

Now select “Megane”,then click “Continue” button

Select “Megane 4 15+”,click “Continue” button

Select “Card key”

For this Renault key programming,it will cost your credits,massage show as below,click “Yes” to continue

Enter total key count to have at the end of the procedure.

Turn ignition off,press “Start/Stop” button,also open driver side door

 

It will take you about 2 minutes to checking flash data,please wait

Press “Continue” button to precode new key to be programmed

Place new key into Zed-Full antenna and press “Continue” button

It will prompt you “Would you like to pre-code” another transponder?

Click “Not” to continue

Then place new key to be programmed to “Start/Stop” button on car and press “”Continue button

Successful

Now we place original working key to “Start/Stop” button on car and press “Continue” button

Successful

Now please wait. Saving log…it will take about 1 minutes

Now you can test all keys on your car.

auto

Recent Posts

QSK60 CM2358 Engine Camshaft Speed/Position Sensor Data Erratic Incorrect

This illustration show you guide on how to repair Cummings QSK60 CM2358 engine camshaft speed/position…

1 week ago

Fendt MT800E Tractor DEF Tank Temperature Does Not Change Solution

Here is the instruction show yo guide on how to solve Fendt MT800E tractor DEF…

1 week ago

HITACHI Construction 4JJ1 P0092 Fuel Pressure Regulator Control Circuit High

Here car-auto-repair.com show you guide on how to solve ISUZU construction 4JJ1 engine P0092 fuel…

2 weeks ago

How to Solve Perkins 1106D EPG Engine E398 Low Fuel Rail Pressure Error

Here is the illustration show you guide on how to solve Perkins 1106D electric power…

2 weeks ago

Deutz EMR3 Aassembly Inspection and Initialisation Test Guide

Here comes the instruction on how to use SerDia2010 to perform assembly inspection and initialization…

2 weeks ago

HITACHI ZX-5 Excavator No Load Max Differential Pressure Measurement Guide

This instruction show you guide on how to perform No load max differential pressure measurement…

2 weeks ago