This instruction show you guide on how to remove and install wheel speed sensor for RSSPLUS trailer.
Related Contents:
Meritor Wabco Toolbox v13.6 v12 Diagnostic Software Download
Remove the Old Sensor
1.Follow the vehicle manufacturer’s instructions to back off the slack adjuster and remove the tire, wheel and drum.
2.Hold the sensor, not the cable, and use a twisting motion to pull the sensor out of its sensor holder.
3.Remove the spring clip from the sensor holder.
4.Remove any fasteners that hold the sensor cable to other components.
5.Disconnect the sensor cable from the extension cable.
Install the New Sensor
Sensor locations vary according to suspension types. Typically, a spring suspension has sensors on the forward axle, and an air suspension has sensors on the rear axle.
1.Apply a mineral oil-based grease that contains molydisulfide to the sensor spring clip and to the body of the sensor. The grease must be anti-corrosive and contain adhesive properties that will
continuously endure temperatures from -40° to 300°F (-40° to 150°C).
2.Push the spring clip into the sensor holder from the inboard side, until the spring clip tabs are against the sensor holder. Push the sensor into the spring clip as far as possible.
3.Route the sensor cable toward the brake chamber, over the brake spider, and behind the axle. Secure the cable to the axle between the brake spider and the suspension brackets. Continue to route the sensor cable behind the spring seats. Secure the cable to the axle one inch from the molded sensor plug.
4.Install the wheel hub carefully, so that the tooth wheel pushes against the sensor as you adjust the wheel bearings. After installation there should be no gap between the sensor and the tooth wheel.
During normal operation a gap of 0.040-inch is allowable.
5.Sensor Output Voltage Test: Use a volt/ohm meter to check the AC output voltage of the sensors
while rotating the wheel at approximately one-half revolution per second. Minimum output must be greater than 0.2 volts AC. If minimum output is less than 0.2 volts AC, push the sensor toward the tooth wheel. Recheck the sensor output.
This instruction show you guide on how to solve Allison 3000 & 4000 Gen5 engine…
Here is the illustration show you guide on how to solve Fendt MT1149 tractor SCR…
Here is the instruction show you guide on how to set play between timing pinion…
Perkins 1106D Generation Injector Data Incorrect Test Guide Preparations: Perkins EST 2024A & 2023A…
This instruction show you guide on how to solve Deutz EMR3 engine error 16/108/APSCD trouble…
Here show guide on how to check high pressure relief valve pressure for Kubota L4701…