Truck Repair

Scania Articulation Control System ACS 10 End Position Sensor Error

This instruction show you guide on how to solve Scania truck articulation control system ACS 10 end position sensor fault codes.

Related Contents:

2024.07 Scania SDP3 V2.61.2 V2.40 Diagnostic Software Free Download

Scania VCI3 Diagnostic Adapter Full Chips

2024 2018 Scania Multi EPC Parts Catalogue Free Download

 

End position sensor, ACS

Error identification

 

The end position sensor is activated even though vehicle speed is so high that the articulation unit should be relatively straight.

 

Cause

Defective end position sensor.

Short circuit or open circuit on the end position sensor circuit.

The plate which activates the end position sensor is deformed or has been moved out of position.

 

Notes

The ACS warning indication is displayed. Limp home mode will be activated.

 

Action

Check the end position sensor.

Check cable harnesses, harness-to-harness and harness-to-component connectors.

Check whether the plate which activates the end position sensor is deformed or has been moved out of position.

For more information about Scania truck,please refer to:Scania Trouble Repair.

auto

Recent Posts

How to Remove Second Tank for CLAAS AXION 960-920 Tractor

This instruction show you guide on how to remove second tank for CLAAS AXION 960-920…

12 hours ago

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

3 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

6 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

1 week ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

2 weeks ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

3 weeks ago