Truck Repair

Scania Truck ATA 114 Auxiliary Heater System Overheating Error

Here is an illustration show you guide on how to solve Scania truck auxiliary heater system overheating error ATA 114.

Related Contents:

2024.07 Scania SDP3 V2.61.2 V2.40 Diagnostic Software Free Download

2023 2018 Scania Multi EPC Parts Catalogue Free Download

Scania VCI3 Diagnostic Adapter Full Chips

 

Overheating

Error identification

The difference in temperature between the temperature sensor and overheat sensor is too great.

 

Cause

Blocked air supply to the auxiliary heater, cold air.

Blocked air vent from the auxiliary heater, heated air.

Faulty flame monitor or control unit.

Check the fuel supply.

 

Notes

Action

Check the fuel supply.

Check that the pipes for air supply or air venting are not blocked.

Check the flame monitor.

Check the overheat sensor.

Instructions for the checking procedures are found in the work description in Multi under 18-90 “H13, ATA Auxiliary heater – air”.

 

For more information about Scania truck,please refer to:Scania Trouble Repair.

auto

Recent Posts

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

21 hours ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

4 days ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

2 weeks ago

How to Adjust Cruise Control Release Linkage for Kubota L3901 Excavator?

This is instruction show you guide on how to adjust cruise control release linkage for…

2 weeks ago

How to do Perform Cylinder Cut-off Test for Massey Ferguson Tractor

This instruction show you guide on how to use AGCO EDT diagnostic software to perform…

2 weeks ago