This instruction show the diagnose steps to solve Scania Truck end position sensor 1 and 2 ACS 37 error.
Related Contents:
2024.07 Scania SDP3 V2.61.2 V2.40 Diagnostic Software Free Download
Scania VCI3 Diagnostic Adapter Full Chips
2024 2018 Scania Multi EPC Parts Catalogue Free Download
End position sensor 1 ACS
Error identification
The end position sensor is activated even though vehicle speed is so high that the articulation unit should be relatively straight.
Cause
Defective end position sensor.
Short circuit or open circuit on the end position sensor circuit.
The plate which activates the end position sensor is deformed or has been moved out of position.
Notes
The ACS warning indication is displayed.
Action
Check the end position sensor.
Check cable harnesses, harness-to-harness and harness-to-component connectors.
Check whether the plate which activates the end position sensor is deformed or has been moved out of position.
End position sensor 2 ACS
Error identification
The end position sensor is activated even though vehicle speed is so high that the articulation unit should be relatively straight.
Cause
Defective end position sensor.
Short circuit or open circuit on the end position sensor circuit.
The plate which activates the end position sensor is deformed or has been moved out of position.
Notes
The ACS warning indication is displayed.
Action
Check the end position sensor.
Check cable harnesses, harness-to-harness and harness-to-component connectors.
Check whether the plate which activates the end position sensor is deformed or has been moved out of position.
For more information about Scania truck,please refer to:Scania Trouble Repair.
This illustration show you guide on how to repair Cummings QSK60 CM2358 engine camshaft speed/position…
Here is the instruction show yo guide on how to solve Fendt MT800E tractor DEF…
Here car-auto-repair.com show you guide on how to solve ISUZU construction 4JJ1 engine P0092 fuel…
Here is the illustration show you guide on how to solve Perkins 1106D electric power…
Here comes the instruction on how to use SerDia2010 to perform assembly inspection and initialization…
This instruction show you guide on how to perform No load max differential pressure measurement…