Here is a short article of Steering Wheel Angle Sensor Learn function by G-Scan on 2018 Chevrolet Bolt EV. This calibration is required after replacing steering angle sensor.If you want to know more about Chevrolet Repair cases, please visit Chevrolet Trouble Repair.
Steps
Connect G-Scan3 to Cherolet Bolt EV obd port, then enter menu to select “Diagnosis”
Select “GM”–> “AUTOMATIC SELECTION”
Click “OK”
Click “OK”
If you replace the steering wheel angle sensor, you need to perform “Steering Wheel Angle Sensor Learn” function using a scan tool.
Select “Steering Wheel Angle Sensor Learn”
Align the front wheels straight and center the steering wheel, after that click “OK”
Click “OK”
Function is completed.
As always, if you want to know more about G-Scan function, please refer to G-Scan test cases.
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…