Launch X431 ADAS Pro the advanced driver assistance system calibration tool is original released by Launch to the automotive ADAS market.It was designed to handle the calibrations after the cameras or a radars are removed,replaced or repaired.It has wide coverage on vehicle models and excellent calibration performance.In this example,it show you how to use Launch X431 ADAS Pro to calibrate front camera for Toyota Camry 2019.For more Camry projects,please follow this tag:Toyota Camry Repair Cases.
Proper calibrations are needed when one or multiple of the following conditions occur:
Front camera replacement
ECU replacement
Windscreen replacement
Structure change
Chassis adjustment
Level sensor replacement
Relevant DTCs(C1AA8:Front camera module incorrect axial gap,C1AA9:Front camera module beam axis not adjusted)
Note:All fault memory records not related to calibration must have been processed.
Preparation:
Park the car on the flat ground and set the steering angle to be zero
Keep the front wheels pointing straight ahead
Empty the car and keep the doors closed
Check the tire pressure and ensure the value is within standard range
Turn off the headlights
Switch on the ignition
Keep front camera lens clean and unobstructed
The light at the field should be bright enough
No reflective or flashing objects around the target
Procedures:
Turn on the ignition
Connect the VCI (vehicle communication interface) to the vehicle
Get access to ADAS system
The ADAS calibration system automatically identifies the VIN code to get the car model
Select “Front Recognition Camera”
Select “Special Function”
Select “Recognition Camera Axis Adjust”
Calibration Setup:
1.Use LAC01-06 target
2.The distance(L) between LAC panel and the front of the vehicle 3000mm
3.ADAS Panel is placed centered in front of the vehicle
4.ADAS Panel is placed parallel to front of the vehicle
5.Adjust the height(H) of the LAC panel to 2000mm
Continue the calibration
Press “OK” to continue
Confirm the following conditions,and press “OK” to continue
Press “One time recognition” then it will prompt you to set up the target at position 1 as instructed in the repair manual
Press OK to continue
Recognition Camera Axis Adjust is complete
More about Toyota Camry repair,here is the collection:Toyota Camry Repair Projects