Categories: Auto Key Program

Toyota Hilux 2010 G Chip 72 All Key Lost Program by OBD(OBDSTAR Key Master)

This post test OBDSTAR X300 key master on Toyota Hilux VIGO 2010 G chip 72 all key programming.

 

And here are some related content:

Toyota All Key Lost Programming

Toyota G Chip Programmig

Toyota Reiz 2010 G Chip All Key Lost Programming

 

Procedures:

Toyota G chip key have G stamped on key

Connect OBDSTAR Key Master to vehicle via OBD port,and enter system menu to select “TOYOTA/LEXUS”à”TOYOTA/LEXUS V31.09”

For all key lost,when you insert the new key the security light don’t off

Turn on the ignition with new key

Operate the OBDSTAR Key master to select “Immobiliser”

Select “Type 2(With G 72)”

Select “Reset immobiliser” (All keys lost)

Follow the prompt to switch ignition off

Then it will prompt to switch ignition on.

Switch the ignition off and remove the key,the press the “ENT” button to continue

Switch ignition on

Now the security light steady prompt

Switch ignition off and remove the key

Then OBDSTAR Key Master will show you below options:

Program keys as the following steps within 120 seconds:

A:Program 2 master keys and 1 sub keys.

1.Insert the first master key,turn on the ignition,and wait for seconds

2.Insert the second master key,turn on the ignition,and wait for 5 seconds.

3.Insert the third sub key,turn on the ignition switch,and wait for 5 seconds.Security light turn off,and programming is finished

B:Program 1 master key and 1 sub key:

1.Insert the first master key,turn on the ignition ,and wait for 5 seconds

2.Inser the second sub key,turn on the ignition switch,and wait for 5 seconds.

3.Turn on the ignition on switch quickly for 5 times.Security light turns off,and programming is finished.

 

C:Program 1 master key:

1.Insert the master key,turn on the ignition,and wait for second.

2.Turn on the ignition switch quickly for 5 times.Security light turns off,and programming is finished.

 

Now the security light is off when you turn on ignition,and it can start the engine.

auto

Recent Posts

JCB JS140/205/215 Excavator C1022-13 Coolant Temperature Sensor Open Circuit

This instruction show you guide on how to solve JCB JS140/205/215 excavator C1022-13 trouble code coolant…

2 days ago

How to Diagnostic and Repair PCC1302 PowerCommand Code 2972 – Field Overload

If the time that the Field AVR Duty Cycle is operating at maximum output is…

3 days ago

Caterpillar C9 Engine 15 164-3 Injection Actuation Pressure Voltage High

The Engine Control Module(ECM) detects the following conditions: The voltage for the injection actuation pressure…

4 days ago

Volvo and Mack EPA 10 Engine Hydrocarbon Dosing Control Valve Test by JPRO

This instruction show you guide on how to perform hydrocarbon dosing control valve test for…

1 week ago

Fendt Tractor SPN 100 FMI 31 Oil Pressure Sensor Defect Solution

This instruction show you guide on how to solve Fendt tractor SPN 100 FMI 31…

1 week ago

Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure

Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure   Related Contents: 2024.06 Detroit Diesel…

2 weeks ago