In this instruction,i will show you how to use VCDS software to code for Skoda Octavia Confort Turn Signal (Cycles).
Preparations:
VCDS Software Download & Installation
Procedures:
Enter menu to select “Control Module”
Select “09-Cent.Elect.”
Select “Adaptation-10”
Open dropdown box to select “Comfort Turn Signals (Cycles)”
Now you can change the value
Current the value is 3,you can change it from 1-5.
Note:Newer control module software version will accept new value but not apply them even after an lgnition/Sleep cycle.In such a case try to perform a “Factory Reset” using the “Light & Vision” menu in the instrument cluster settings (by using the multi function display/indicator)
Here change it to value 5,then click “Test” button and click “Save”
You also can click “Read” button to check if the value have changed correctly.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…