Here car-auto-repair.com show a guide on how to use VCDS to do ABS coding for Audi A4.
Preparations:
VCDS 17.8.1 Full+Loader V2/V4 Free Download
Main Procedures:
1.Identify the type of ABS module
2.Locate the PR Codes for the brakes
3.Identify the type of engine and transmission
4.Generate the login and soft coding
5.Perform ABS Coding
Step 1:Identify the type of ABS Module:
Launch VCDS software,then click “Select” button to select control module
Select “03-ABS Brake”
Now you can see the ABS type(yellow arrow),it show “Bosch ESP 5.7….”
Step 2:Locate the PR Codes for the brakes
Production Code (PR-Codes) can be found on the vehicle data label
The PR Codes can be found in one of two places on the vehicle:
1.On the sticker near the Spare Tire Well on the floor of the vehicle.
2.The duplicate of that sticker on the 1st Page of the Service/Maintenance Manual in the Owner’s Manual.
1LE
8E
Step 3:Identify the type of engine and transmission
Click “02-Auto Trans”
Component:”V30 01J….” “AQ 250 6F…”
Step 4:Generate the Login and Soft Coding
Here is the vehicle informations:
Login:09579
Coding:04279
Step 5:Perform ABS Coding
Click “03-ABS Brake”
Click “Login-11”
Input the value “09679”,then click “Do It”
Click “Coding-07”
Input the value “04279”,then click “Do It”
Now the Soft.Coding “04279”
Click “Login-11”
Input the value “40168”
Note:40168=Basic Settings Enabling (i.e mandatory prior to Steering Angle Sensor Alignment)
Turn steering wheel left about 90 degree
Back
Measuring Blocks
Done!Go Back
Basic Setting-04
Click “Go”
Done!