Categories: Auto RepairHow To

VCDS Solve MMI “03276 PLEASE CHECK SOFTWAE VERSION MANAGEMENT” Error Massage

This article show a guide on how to use VCDS to remove/solve Audi MMI “03276 PLEASE CHECK SOFTWAE VERSION MANAGEMENT” Error Massage.

 

Preparations:

VCDS 17.8.1 Full+Loader V2/V4 Free Download

 

Note:For more about Audi MMI Repair articles,please check:Audi MMI Repair,and more VCDS projects check:VW VCDS Projects

 

Procedures:

Open VCDS and inside “Select Control Module” click on “Select” button

Select module “5F”

Click on “Adaption – 10”

Enter “15” for the channel and press the “Read” button

Copy the number in “Count” field

Using a scientific calculator make the next formula:

YourCountNumber ^ 51666

Or

YourCountNumber XOR 51666

Now enter the result into the “New Value” field and click “Test” and “Save”

Note that only “Save” may be available in which case you would ignore the “Test” button

Exit Adaptations and return to the main screen (Click “Done, Go Back)

Click “Fault Codes – 02”

If you see any Faults click “Clear Codes – 05” then “Done, Go Back”

Now check Fault Codes one more time and the SVM error should be gone. If not, repeat the steps again.

Info: In the event you go to Channel 15 and there is no Count value, clear your errors and then go back recheck. Sometimes the count will not be present until the error is cleared. Of course the error will return until you complete all the above steps again

auto

Recent Posts

JCB JS140/205/215 Excavator C1022-13 Coolant Temperature Sensor Open Circuit

This instruction show you guide on how to solve JCB JS140/205/215 excavator C1022-13 trouble code coolant…

2 days ago

How to Diagnostic and Repair PCC1302 PowerCommand Code 2972 – Field Overload

If the time that the Field AVR Duty Cycle is operating at maximum output is…

3 days ago

Caterpillar C9 Engine 15 164-3 Injection Actuation Pressure Voltage High

The Engine Control Module(ECM) detects the following conditions: The voltage for the injection actuation pressure…

4 days ago

Volvo and Mack EPA 10 Engine Hydrocarbon Dosing Control Valve Test by JPRO

This instruction show you guide on how to perform hydrocarbon dosing control valve test for…

1 week ago

Fendt Tractor SPN 100 FMI 31 Oil Pressure Sensor Defect Solution

This instruction show you guide on how to solve Fendt tractor SPN 100 FMI 31…

1 week ago

Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure

Detroit GHG17 Heavy Duty Engine Piston Protrusion Measurement Procedure   Related Contents: 2024.06 Detroit Diesel…

2 weeks ago