You can read and write anew/overwrite the EEPROM of the supported vehicles/ECUs using the VCP. So here show the simple process on read write edit on EEPROM of VW ECUs.
Preparations:
How to Install VCP System Diagnostic Tool Software
VCP System Professional Diagnostic Tool Software Download
Main Procedures:
In the Details page of a particular ECU you can press UP/Download (1) to open the HEX Editor. Adjust the type of diagnostic session (2).
Required Diag. Session (1) for EEPROM read/write test (in case if this was set for the particular ECU beforehand). Record the necessary login data (2), define the address (3), set memory size (4), then read and load (5) the current information, as necessary.
After a successful reading, perform the necessary adjustments and overwrite (6) the EEPROM.
This instruction show you guide on how to remove and install crankshaft rear seal for…
This instruction show you guide on how to use JPRO diagnostic to do SCR performance…
Here is the instruction show you guide on how to remove and disassemble master cylinder…
This instruction show you guide on how to solve Deutz EMR engine 71 / 2791 /…
Here is the instruction show you guide on how to repair P0731 incorrect 2nd gear ration…
Here is the how to use guide on Caterpillar machine misfire detection test by CAT…