Categories: ECU Chip Tuning

VF2 Flasher Read/Write Data for BMW 6HP TCU without Removal

In this instruction car-auto-repair.com will show you guide on how to use VF2 Flasher to read or write data for BMW 6HP removal.The tool is able to read and write the full contents of the control unit without the need to open or desmantle it.

 

Procedures:

Connect VF2 Flasher to BMW 6HP unit with the cable

Enter menu to select “ECUs”–>”Bench”–>”Vehicle Engine Model”–>”Car”–”BMW”

After then depend on your BMW 6HP TCU model to select “2.0l Bosch…”

Press “Select”

Identification in progress

 

After identification success,now perform reading

 

Checksum in progress

After reading success,you now just save the file on the VF2 Flasher programmer.

And you can modify the data,then write it back.

 

More project of VF2,please check here:VF2 Flasher Feedback

auto

Recent Posts

How to Remove Second Tank for CLAAS AXION 960-920 Tractor

This instruction show you guide on how to remove second tank for CLAAS AXION 960-920…

20 mins ago

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

3 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

5 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

1 week ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

2 weeks ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

3 weeks ago