This instruction show you guide on how to perform hydrocarbon dosing control valve test for Volvo and Mack EPA 10 engine by JPRO diagnostic software.
Related Contents:
2024 JPRO Noregon Commercial Fleet Diagnostics Free Download
The Hydrocarbon Dosing Control Valve Test is supported on:
✓ Mack and Volvo all EPA 10 engines
The Hydrocarbon Dosing Control Valve Test activates the aftertreatment dosing control valve to ensure it is operational. You must observe the valve while the test is running to make sure it is working
Procedures:
1 Select Hydrocarbon Dosing Control Valve Test and press Enter or click Start button.
2 The test dialog will be displayed.
3 Select the Start button to begin the test. The valve will be activated for a maximum of 5 seconds.
4 Observe the valve while the test is running to make sure it is working properly.
5 Select the Stop button to stop the test at any point. The test will automatically stop after 5 seconds.
6 Once the test has been completed, click the Exit button to return to the test selection dialog.
More topics about JPRO Diagnostic,please refer to:JPRO Diagnostics Guide
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…
This instruction show you guide on how to use AGCO EDT diagnostic software to perform…
This instruction show you guide on how to remove folding stairway and surrounding part for…