Here is an instruction show you guide on how to replace engine rotation crankshaft speed sensor for Volvo EC250E LRC4 excavator.
Related Contents:
2024 Volvo TechTool PTT 2.8.241 APCI 0.7.1.0/2.7.116 All Version Free Download
Volvo PROSIS 2023 2019 2018 Parts Catalog & Repair Manuals Free Download
Volvo Diagnostic Kit (88890300)
Volvo VOCOM 88890300 Diagnostic Kit
Procedures:
Total procedure time (hr): 0.60
1.Place the machine in position A according Service positions.
2.Turn Off the battery disconnect switch.
3.Remove the filters and pump room covers.
4.Clean around the crankshaft speed sensor.
Disconnect the speed sensor connector.
5.Remove the crankshaft speed sensor from the engine.
6.Check that the O-ring on the new speed sensor is undamaged and positioned correctly. Lubricate the outside of the O-ring with grease.
O-ring, speed sensor
7.Install the new crankshaft speed sensor.
Tightening torque, refer to Engine, tightening torques
NOTE!
Ensure that the speed sensor is fitted correctly in the flywheel housing.
8.Connect the speed sensor connector.
9.Reinstall the filters and pump room covers.
10.Turn ON the battery disconnect switch and check the sensor’s function.
More repair case for Volvo excavator pls refer to:Volvo Excavator Trouble Repair
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…
This is instruction show you guide on how to adjust cruise control release linkage for…