Categories: Auto Repair

Volvo XC90 2019 Fuel Trim Adaptation Function Reset by Launch X431

This instruction show you guide on how to reset adaptation function fuel trim P01700 trouble code for Volvo XC90 2019 by Launch X431.

 

Preparations:

Launch X431 PAD V

 

Procedures:

Connect Launch X431 to Volvo XC90,then power on Launch X431 and select Volvo Brand perform automatically search.

Select “Read Fault Code”

Then back to select “Clear Fault Code”

Select “Special Function”

Select “Reset The adaptation function of the fuel/air mixing (Fuel Trim)”

This Reset Must Be Performed After Rectified The Stored Diagnostic Trouble Code (DTC) Because The Control Module Has Reached Its Fuel Compensation Limit, I. E. It Can Not Compensate FOr More, Or Less Fuel To Reach The Oxygen Content 1. The Reset Also Contributes To Other Types Of Fault Tracing And Practices, Such As When Rectifying The Air Leakage. The Engine Control Module (ECM) Stores The Adaptive Value Of The Learnt Fuel/Air Mixed Ratio.

 

When Change The Components Connected To The Control Module, The Relevant Adaptive Values Should Be Reset.Perform A Reset So That The Control Module Can Quickly Learn About The New Components And Their Features And Their Impact On The Surrounding Components And Functions.

*Set The Vehicle As The “Start The Usage Mode”.

*start The Reset.

*set The Vehicle As The “Not Start The Usage Mode”. Wait For 3 Minutes.Warning! After Completed, The Control Module Can Be Kept In Standby Mode To Reset The Data Stored In Memory.

Notice! If The Above Procedure Is Not Performed Correctly, The Control . Module Will Retain The Old Adaptive Values, or It Should Be Noticed That An Incorrect Adaptive Value Will Occur After Next Data Test, Which May Result,For Example, The Negative Symptoms Related to the driving performance and/or fuel consumption

Click “OK”

Now finish

 

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

1 day ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago