Categories: Auto Key Program

VW 4 th Immobilizer Skoda Superb,Sagitar Key Programming Guide

Last month,I wrote article on topic of How To Program For VW 3 Gen Immobilizer System and VW 3+ Gen Immobilizer System Programming Guide.And In this article I will go on this topic of How to Program Key for VW 4 th immobilizer Skoda Superb,Sagitar.

Here I take Skoda Superb,VW Sagitar(vehicle model equipped with 24C64 chip ) as example.

And this method also apply to new Passat(non-multi color dash),new Tiguan.

 

Procedures:

Use VVDI Immo Plus program key,and generate key NEC+24C64(all key lost)

 A.Dismantle the dash,and remove the chip 24C64 from dash pcb.And read out the data file from 24C64 chip by BDM,and save the data file at your laptop.

 B.Enter “NEC 24C64 Mode”,select “Generate special login 24C64 EEPROM” to obtain special login file of current EEPROM.Then write the login file into 24C64 chip,and weld it back on dash pcb,and restore your dashboard.

 C.Select the function “obtain login data” to obtain the login configuration file,and save it as spare.

 D.Generate a work key.(Achieve by NEC+24C64 function)

 

8 steps to generate a work key:

1. Esc to select “all key lost”–>”Special login mode”–>”NEC+24C64 mode”–>”Login by login data”

2. Then select “NEC+24C64” at drop-down list,load the data file read out by BDM before,and then click”write into EEPROM” to write original data file into EEPROM list.

3. Back to “All key lost”–>”Special login mode”–>”NEC+24C64 mode”–>”Login by login data”

4. Select “NEC+24C64” at drop-down list,click to read out immo data file,and save it.

5. Back to “All key lost”–>”Special login mode”–>”NEC+24C64 mode”–>”Login by login data”

6. Select “NEC+24C64” at drop-down list,and click to generate a dealer key,it will generate a new dealer key.

7. Back to “All key lost”–>”Special login mode”–>”NEC+24C64 mode”–>”Login by login data”

8 Select key add function,add the new dealer key into immo system,and then the key you program just now can start the engine.

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

2 days ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

4 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

1 week ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago