Categories: How To

VW Audi VL381 Gearbox Module Clone by Launch X431 IMMO Pro

Here is a step by step guide on how to use Launch X431 IMMO Pro device to clone VL381 gearbox control unit for VW and Audi. And for more about VW repair,please refer to Volkswagen trouble repair.

 

Devices Used:

LAUNCH X431 IMMO (Amazon Official Shop)

 

Procedures:

Power on Launch X431 IMMO Pro,then enter menu to select “Gearbox”

Select “VL381(0AW)”

Select “View Wiring Diagram”

Please connect ECU to the diagnostic connector according to the diagram show

 

Back to select “Connect”

Select “Backup EEPROM Data”

Save it on your device (Launch X431)

Same operation steps to back up Flash Data and save file.

Now disconnect old gearbox unit and plug a new gearbox unint.

Select “Restore EEPROM Data”

Select the EEPROM data file you save just now

Same operation step to restore FLASH data

After both finish,click “Disconnect”

Done!

More test report about Launch X431 please check:Launch X431 Test Report

auto

Recent Posts

Doosan Excavator P0408 Maximum EGR Rate Governor Deviation Error Solution

This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…

1 day ago

How to Calibrate 2403 Steering Valve for Fendt 800 S4 Tractor

Here is the instruction show you guide on how to calibrate 2403 steering valve for…

3 days ago

Massey Ferguson Tractor Electrohydraulic Spool Valves Configuration

This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…

6 days ago

How to Remove Center Joint and Center Frame for HITACHI Hitachi EX5600-7B

This instruction show you guide on how to remove center joint and center frame for…

1 week ago

How to Repair Doosan Machine P0100 DTC Signal Error

How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…

2 weeks ago

How to Solve Fendt 800 Vario S4 wayline Running Slow

If the vehicle is oscillating on the wayline or catches up the wayline very slowly…

3 weeks ago