In this instruction,car-auto-repair.com show you the procedures on how to use Zed-Full immobilizer programmer to perform keyless go programming for VW Passat 2015 MQB system.
And for more Volkswagen key programming case,check here:VW Key Programming.
For VW Passat topic,please check this tags:VW Passat Repair
Procedures:
Connect Zed-Full to VW Passat obd port
Select [OBD Application]
Select “VAG” vehicle brand
Select [Auto Detect] and click Continue button
Turn ignition ON with working key by press “Start-Stop” button then press Continue button
Vehicle system is detected press “Continue” button
Select extract pin code then press Continue button
It will cost you 20 credits if the pack is not loaded,click “Yes” to continue
Turn ignition ON,then press Continue button
To extract pin code and CS instrument cluster will be reset then the cluster will be taken to programming mode.Click “Yes” button
If you get “Turn ignition ON with a programmed key” massage,remove the battery of the working key then turn ignition on.
Hold the working key (without battery) close to the ignition then press Start/Stop button.Cluster lights will be on.
Keep holding the key close to the ignition then select “Extract pin code”
Keep holding the key close to the ignition then press Continue
Click “Yes”
Checking flash data…
Pin code and CS is extracted press Continue
Zed-Full is saving log file,it may take up to 30 seconds.
When completed Zed-Full will go back to previous menu automatically.
After extracting pin code put back the battery to the working key
Since the car has a keyless go key,select “Prox Key” key menu
Key information show as below
New key to be added must be precoded first so select “Yes”
Select vehicle brand as VW
Insert the working key to the Zed-Full Antenna first then press Continue
Insert the new key to be programmed to the Zed-Full antenna then press “Continue”
Key is precoded.
We do not want to precode another key so press “No”
Input total key amount to be programmed then press “OK”
Make sure the ignition is on.
If the cluster lights are not on press “Start-Stop” button once then press “Continue”
Hold the key close to the antenna the press Continue
When key is programmed the number on the cluster will change from 0-2 to 1-2
Hold the second key to the antenna then press “Continue”
Then the second key is programmed the number on the cluster will change from 1-2 to2-2.
To leave programming mode procedure must be completed,this may take around 10 seconds.If the car won’t leave programming mode repeat the key programming step again.
Done!