In this instruction car-auto-repair.com show you guide on how to use XTOOL AutoProPAD programmer to reflash/initialize immobilizer system for Toyota/Lexus.More topics about Toyota immobilizer,please check here:Toyota Key Programming
What You Need?
XTOOL AutoProPAD Programmer
XTOOL EEPROM Adapter Set
Toyota/Lexus Immbilizer Box
Procedures:
Plug the EEPROM PCB to EEPROM adapter,and rainbow cable on the EEPROM PCB
Connect clip to the rainbow cable
Build connection between XTOOL AutoProPAD and EEPROM adapter
And provide 12v power for EEPROM adapter
Enter menu to select “Other Service”
Select “EEPROM Adapter”
Select “Data initialization”
Make sure the adapter is connected and powered on,the status light is turned on
Press “OK” to contine
Select “Toyota”
Now locate the IC900 on the Toyota immobilizer system box
Use 8 pin clip to clamp the chip
Press “Toyota 16 bit (93C56)”
Then input the file name to make a backup on the XTOOL AutoProPAD,in case immobilizer data damaged during reflashing.
Press “No” to continue
And the file is saved successfully
Whether to continue
Press “Yes” to continue
Repair the data…
Data initialized successfully!
Now install the immobilizer box back on Toyoa/Lexus,then just do regular key programming proceudres.
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…