In this instruction,car-auto-repair.com will show you the procedures on how to use Zed-Full to program new keys for Ford Transit 2017+.And if you want to get more ford key programming,please check here:Ford key Programming.
Procedures:
Connect Zed-Full to Ford Transit OBD port
Select “OBD Application”
Select “Ford EU”–>”Transit” and press “Continue”
Select “Transit 17+”,then click “Continue”.The transponder type is HITAG PRO
Select “Add key”,if you are willing to add key only
Here we need to “Delete keys”
All previously programmed keys will be deleted.Before starting,make sure you have all keys you aw want to program.At least 2 keys must be coded.Turn ignition On with the key to be programmed,then press “Continue”
Connection is successful.VIN number and BCM part number is as shown on screen,the click “Continue” button
Now Zed-Full Programmer will take about 5-6 minute to reading eeprom,please wait
Turn ignition off and ON,then press “Continue” button
All keys are deleted successfully
Turn ignition ON with the new key to be programmed,the press “Continue”
Key programming complete,if you want to add another key press “Continue”
Just repeat to program another key.
Done!
This instruction show you guide on how to solve Doosan excavator P0408 maximum EGR rate…
Here is the instruction show you guide on how to calibrate 2403 steering valve for…
This function requires all connectors to be disconnected from all electrohydraulic valves on the tractor.You…
This instruction show you guide on how to remove center joint and center frame for…
How to solve Doosan heavy duty machine P0100 fault code signal error of air mass…
If the vehicle is oscillating on the wayline or catches up the wayline very slowly…